Extending from 23.6 all the way to 59 inches, this support bar covers a far wider span of hull and trailer geometries than a short fixed brace, which makes it the practical choice for an owner who runs more than one boat or changes trailers. Rated for outboards up to 150 horsepower, it takes the engine weight onto the trailer frame and away from the stern, cutting the vibration and shock loading that eventually cracks a transom on long tows. A composite head cushions the motor contact point, and Q235B steel with an ADC-12 head and galvanized coating resists rust through rain, road salt and ramp immersion. Setting the length only requires measuring between the outboard and the trailer before fitting, and one person completes installation without special tools. Overall size is 61.81 by 7.09 by 4.76 inches at 9.81 pounds. Inspect the fittings after long trips.
Spans 23.6 to 59 inches: The wide adjustment range fits fishing boats, pontoons and speedboats on different trailers, so one bar serves an owner who runs several hulls rather than buying a brace each.
Rated to 150 horsepower: The bar supports outboards up to 150 HP, transferring engine load onto the trailer frame and keeping the stern from carrying the mass alone over long highway tows.
Composite head at the motor: A composite contact head cushions the point where the bar meets the engine, spreading pressure instead of concentrating it on the lower unit during road vibration.
Galvanized against salt: Zinc coating over Q235B steel with an ADC-12 head resists corrosion through rain, road salt spray and repeated launch ramp immersion across a full boating season.
Fits without special tools: Measure motor to trailer, set the length and install single-handed at 61.81 by 7.09 by 4.76 inches and 9.81 pounds. Wipe dry after use. Imported. Intended for adult use, 18 and over.
Q235B Steel, ADC-12 Aluminum Alloy
Wipe clean
Imported
Style Variants
Available Colors: Silver
Size Reference for SUGIFT Motors Under 150 HP
Available Sizes:
