Bottom mounting and a 55 degree installation angle pull these two steps in close to the trailer frame, where a triangular support structure carries the load without the wobble that plagues bolt-on ladders. Q235B carbon steel forms the frame and the surface receives electrophoresis treatment followed by powder coating, a two-stage finish aimed at salt water exposure at the ramp. The base plate accepts left, centre and right positions and clamps to 3 by 3 inch, 3 by 5 inch or 4 by 4 inch cross beams, which covers most common trailer builds. Each step is widened and fitted with a rubber non-slip mat, and rounded edges reduce shin knocks while climbing in wet conditions. A handrail gives a third point of contact so boarding and stepping down both stay controlled. Assembled dimensions are 60.04 by 17.95 by 12.12 inches at 16.97 pounds, and installation needs no frame modification.
Fits three cross beam sizes: The base plate clamps to 3 by 3 inch, 3 by 5 inch or 4 by 4 inch beams in left, centre or right positions, covering most common bunk-style trailer builds.
55 degree triangular support: The close-fit angle and triangular bracing carry weight without the wobble that affects bolt-on ladders, so each step feels solid underfoot when boarding.
Two-stage corrosion finish: Electrophoresis treatment under powder coating protects the Q235B carbon steel against the salt water and spray a trailer meets at a coastal boat ramp.
Widened steps with rubber mats: Enlarged tread plates and rubber non-slip mats improve traction in rain, while rounded edges lower the chance of shin knocks during a wet climb.
Handrail included at 16.97 pounds: The rail adds a third contact point and assembled size is 60.04 by 17.95 by 12.12 inches. No frame modification is needed. Wipe clean with a damp cloth. Imported.
Wipe clean
Imported
Style Variants
Available Colors: Black
Size Reference for SUGIFT Surface for 3 Beam Sizes
Available Sizes:
